| |
|
|
| |
Resistant: |
|
| |
 It is resistant to Oxidizing & Non-oxidizing Acids, & Chlorine Gas except Hydrofluoric Acid.
|
|
| |
Resistant to temperature: |
|
| |
1000° C (Max.)
|
|
| |
Preparation of Mortar: |
|
| |
Preparation of Mortar generally consists of Solution & Powder. In order to obtain good working consistency, the average mixing ratio is 1 Pbw of Solution & 3 pbw of Powder. This ratio will slightly vary depending upon the temperature and working conditions.
Prepare small batches of Mortar. Stirrer the Solution thoroughly before use. Place the Solution in a suitable mixing pan and add powder in it. Mix thoroughly with a spatula or Trowel. The mixing operation shall be continued until a uniform mixture is obtained.
Make sure that all the Mortar is used from the mixing pan before another batch is prepared.
Surface Preparation:
The cement plastered surface shall be slightly rough in line & level , dry & clean, free from dust, dirt, grease, oil etc., maintaining required slope etc. as no slope can be adjusted or altered in Acid proof lining works.
Setting/Curing:
Furomor Resin Mortar is a Self-hardening due to its chemical reaction which occurs when the Powder & Resin are mixed together.
An initial setting occurs in 6 to 8 hrs. at 30°C
Final Setting occurs in 24 to 48 hrs. at 30°C
Curing time: 7 days at 30oC
Please ensure that no water shall be spilled over the bricks lining works before it completely cured.
|
|
| |
Potassium silimor™ mortar cond.. (Acid Resistant Mortar) |
|
|
| |
|
|
| |
Acid Curing: |
|
| |
|
|
| |
When the bedding & jointing mortar is different, after the bedding mortar is properly set, cure the joints for a minimum period of 72 hours with 20 to 25% HCL acid before applying the resin type mortar. After acid curing, wash the free acid in the joints with clean water & allow sufficient time for thorough drying. Resin mortar shall then be filled into the joints. |
|
| |
|
|
| |
Mechanical/Physical property: |
|
| |
|
|
| |
| Working time at 30 oC |
: 20 minute (min) |
| Density of cured mortar |
: 2 grm per cc |
| Bond strength |
: 5 Kg.Cm2 |
| Compressive Strength |
: 150 Kg/Cm2 |
| Flexural Strength |
: 40 Kg/Cm2 |
| Toluene Absorption |
: Max. 18% |
|
|
| |
|
|
| |
Storage Life |
|
| |
Solution : 24 Months at the temperature 30°C (+2°C)
Solution : 24 Months at the temperature 30°C (+2°C)
All two components are stored in cool and dry place under the
roof until ready to use it original unopened (Sealed) containers.
|
|
| |
Packing |
|
| |
Solution : 75 Kg. in M.S. Drum
Powder : 50 Kg. in Plastic Bag.
|
|
| |
Export packing |
|
| |
( As per customer’s requirement)
|
|
| |
|
|
